It's been a while since I've logged in, I finally finished my bachelor's degree in May; and have been enjoying the freedom of getting my life back. hehe
Now I have the time to attend to the studio I've put together over the last 2 years while I was a student. I've run into a problem, and after consulting manuals...I'm still a little confused and need input from my peers.
Hardware involved: MacBookPro - OSX Leopard, Edirol UA-25 audio interface (external), Edirol M-10DX digital mixer, Yamaha AN1x, and Virus A Rack.
Situation: I cannot find a way to connect both the Yamaha and Access together and get them to show up in Cubase. I think the issue lies with the digital mixer, but I'm not sure. When I connect the Yamaha to the digital mixer, I get the audio out of the synth but I cannot seem to get Cubase to record it. I can use it as a midi controller in Cubase for any vsti in Cubase, however, and I can also play it via midi data in a midi channel. So now I just need to figure out how to get the outputs of the synths to show up in Cubase's mixer with their own channel/bus.
Anyone have any suggestions?